• To reject the call with “2142622000” Caller ID incoming call:
PRG 14-01-27: 1 (reject)
PRG 20-07-25: 1 (Enable for COS)
PRG 22-16: 32 (Speed Dial group 32)
PRG 13-02; Group 32: 1000 - 1099
PRG 13-04-01; Table 1000: 2142622000
then,
Turn on the Caller ID Refuse mode using the service code (PRG 11-10-34) or Programmable Function
Key (code 87).
• To transfer the call with “2142622000” Caller ID incoming call to extension 301 as ring pattern 1:
PRG 13-04-01: 2142622000
PRG 13-04-03: 1 (extension number)
PRG 13-04-04: 301 (extension 301)
PRG 13-04-05: 1 (tone pattern 1)
• To transfer the call with “2142622000” Caller ID incoming call to incoming ring group 2 as ring
pattern 2:
PRG 13-04-01: 2142622000
PRG 13-04-03: 2 (incoming ring group)
PRG 13-04-04: 2 (group 2)
PRG 13-04-05: 2 (tone pattern 2)
Conditions
• Caller ID Matching. The SL1000/SL1100 compares the Caller ID and programmed Speed Dial and
allows/denies as indicated below.
• The Speed Dial table is searched from the starting number and the first match result is used.
• The maximum number of VRS message channels that can be used simultaneously is 16. These
channels are also shared with the voice mail.
• This feature does not work with incoming trunk calls via networking (from another system).
In this case, the refuse/routing program must be programmed in the system that has those trunks.
Routing to the other system’s extension is available.
• When PRG 13-04 is used; it will override the setting in PRG 22-02-01: Incoming Call Trunk Setup.
• PRG 13-04 will follow Common or Group Speed Dial numbers.
Caller ID Matching Rule:
The system compares the Caller ID and programmed Speed Dial with these rules below.
Table 1-8 Caller ID Matching Rule
Caller ID Speed Dial Result
2142622000 2142622000 Matched
2142622000 21426220009 Matched
2142622000 214 Matched
2622000 2142622000 Unmatched
2142622000 2622000 Unmatched
The Speed Dial table is searched from the starting number and the first match result is used.
Default Settings
Not Installed
ISSUE 2.0
SL1000/SL1100
Features and Specifications Manual 1-115
C
To Next Page
Loading...
