NEC SL1000 - Table 1-7 Keys for Entering Names

8. Enter the name to be associated with the stored number.
Table 1-7 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1 Enter characters: 1 @ [ ¥ ] ^ _ ` { | } Á À Â Ã Å Æ Ç É Ê ì ó 0
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters: 0 ! “ # $ % & ’ ( ) ô õ ú å ä æ ö ü α ε θ В
*
Enter characters:
*
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
# # = Accepts an entry (only required if two letters on the same key are needed -
ex: TOM). Pressing # again = Space. (In system programming mode, use the
right arrow Softkey instead to accept and/or add a space.)
Clear/Back or DND/CONF (SL1000)
DND (SL1100)
Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
9. Press Hold key. The display shows:
SET ABB
10. Press Speaker key.
The telephone returns to idle.
Storing a Number (When 15-02-60: 1 or 2)
To store a Caller ID number in a Common Speed Dial bin: (SL1000)
1. With a Multiline Terminal in an idle condition the display shows:
WED 22 1:59PM
Check List
2. Press Enter Cursor key. The display shows:
100:OPRN LST 1/6
>Call History:xx
xx = List Number
SL1000/SL1100
ISSUE 2.0
1-108
Caller ID
C