4. Dial telephone number you want to store (up to 36 digits).
Valid entries are 0~9, # and
. To enter a pause, press Transfer key. To store a Flash, press Flash
key.
Enter @ for await answer before sending following digits on ISDN.
5. Press Hold key.
6. Enter the name associated with the Speed Dialing number.
Table 1-1 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1 Enter characters: 1 @ [ ¥ ] ^ _ ` { | } Á À Â Ã Å Æ Ç É Ê ì ó 0
2 Enter characters: A-C, a-c, 2.
3 Enter characters: D-F, d-f, 3.
4 Enter characters: G-I, g-i, 4.
5 Enter characters: J-L, j-l, 5.
6 Enter characters: M-O, m-o, 6.
7 Enter characters: P-S, p-s, 7.
8 Enter characters: T-V, t-v, 8.
9 Enter characters: W-Z, w-z, 9.
0 Enter characters: 0 ! “ # $ % & ’ ( ) ô õ ú å ä æ ö ü α ε θ В
Enter characters:
+ , - . / : ; < = > ? π Σ σ Ω ∞ ¢ £
# # = Accepts an entry (only required if two letters on the same key are needed -
ex: TOM). Pressing # again = Space. (In system programming mode, use the
right arrow Softkey instead to accept and/or add a space.)
Clear/Back or DND/CONF (SL1000)
DND (SL1100)
Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
7. Press Hold key.
8. Press Speaker key to hang up or repeat steps 3~7 to program another System or Group Speed
Dial bin.
To dial a System Speed Dialing number
1. Go off-hook.
2. Dial #2.
3. Dial the System Speed Dialing Bin Number.
To dial a System Speed Dialing number by Directory Dialing (display telephones only)
<When PRG 15-02-60: 0>
1. On-Hook condition.
2. Press Right Cursor key until ABB:Common menu appears.
3. Press Up Cursor key or Down Cursor key to select the destination name.
4. Press Speaker key or Lift handset.
<When PRG 15-02-60: 1 or 2>
1. On-Hook condition.
2.
Press Down Cursor key and press 1
st
character you want to search.
3. Press Up Cursor key or Down Cursor key to select the destination name.
SL1000/SL1100
ISSUE 2.0
1-8
Abbreviated Dialing/Speed Dial
A
To Next Page
Loading...
