Clock/Calendar Display/Time and Date
Description
The system uses Clock/Calender Display/Time and Data for:
• Central Office Calls (Access Maps)
• Class of Service (Class)
• Direct Inward Lines
• Display Telephones
• Night Service (Automatic)
• Programmable Trunk Parameters
• Ring Groups
• Station Message Detail Recording
• System Reports
• Toll Restriction (Class)
• Trunk Group Routing
• Voice Mail
• Voice Response System
Using the Daylight Savings Setup program, you can determine whether the system should
automatically adjust the system time for daylight savings time/standard time changes.
Clock Adjustment
The system can be programmed to automatically adjust the system clock on a nightly basis. This
feature allows you to make adjustments should the system cabinet regularly lose or gain time.
Conditions
• The system retains the Clock/Calendar Display after a power failure or system reset.
• Changing the time may change the current Class of Service (COS) service depending on the COS
mode setup.
• You can program the system to automatically switch modes.
• Single Line Terminals cannot set the time and date.
• Changing the system time automatically changes the InMail time.
Default Settings
Enabled
System Availability
Terminals
All Multiline Terminals with a display
Required Component(s)
None
ISSUE 2.0
SL1000/SL1100
Features and Specifications Manual 1-141
C
To Next Page
Loading...
