Program Num-
ber
Program Name Default
15-10-01 Incoming Virtual Extension Ring Tone Order Setup 0 = Tone Pattern 1
1 = Tone Pattern 2
2 = Tone Pattern 3
3 = Tone Pattern 4
4 = Incoming Extension Ring Tone
5 = Tone Pattern 5 (SL1000)
6 = Tone Pattern 6 (SL1000)
7 = Tone Pattern 7 (SL1000)
22-03-01 Trunk Ring Tone Range 0
Table 1-52 Intercom or Trunk Ring Setting
1 = High 5 = Ring Tone 2
2 = Mid Range 6 = Ring Tone 3
3 = Low 7 = Ring Tone 4
4 = Ring Tone 1 8 = Ring Tone 5
Operation
To change your extension incoming ring tones:
1. Press Speaker key.
2. Dial 820.
3. Dial 1 to set Intercom ring; 2 to set trunk ring.
4. Dial code for the desired ring pattern (1~7 (IP Terminal is 1~8) (SL1000) 1~8 (SL1100)).
5. Press Speaker key to hang up.
To listen to the incoming ring choices:
1. Press idle Speaker key.
2. Dial 811.
3. Dial 1 to listen to Intercom ring; 2 to listen to trunk ring.
4. For Intercom Ring:
Dial the code for the ring pattern you want to hear (1~7 (IP Terminal is 1~8) (SL1000) 1~8
(SL1100)).
- OR -
For Trunk Ring:
Dial code for the ring pattern you want to hear (Incoming Ring 1-7) (SL1000)
Dial code for the ring pattern you want to hear (Ring 1~3, Melody 4~8). If you select Ring 1~3, a
second screen prompts for the tone pattern (1~4). (IP Terminal) (SL1000)
Dial code for the ring pattern you want to hear (Ring 1~3, Melody 4~8). If you select Ring 1~3, a
second screen prompts for the tone pattern (1~4). (SL1100)
5. Press Speaker key to hang up.
ISSUE 2.0
SL1000/SL1100
Features and Specifications Manual 1-627
S
To Next Page
Loading...
