Maintenance
Description
The SL1000/SL1100 system has several utilities to assist in troubleshooting and diagnosing problems
both during and after installation.
Side Tone Auto Setup
Per each analog trunk (or all analog trunks) the most suitable Codec Filter setting for PRG 81-07 can
be automatically adjusted using PRG 90-68-01 and 02.
During the trunk measurement process, the following LCD indications are provided.
• During measurement: Measurement (x/5)
x= number of measurements
• Measure complete: Complete
• Error condition: Error
• Trunk busy: Busy
After successful measurement, the option to copy the same settings to all analog trunks is shown.
Side Tone Auto Setup available when the system is in an idle condition.
Remote maintenance using PCPro
PCPro can remotely access the SL1000/SL1100 for maintenance and diagnostics. Within PCPro, the
debug terminal can be accessed to monitor the systems activity and logging. PCPro also has built-in
reports that can display alarm data. If need be, an option in PCPro allows the technician to reset or
initialize the system remotely. If the technician determines the problem is isolated to a specific slot,
PCPro can reset only the slot in question.
Quick System Check-up
You can check the System Information, VoIPDB Information and IP Address by doing a simple
operation. Here are the information you can get from the operation mode: (For future information refer
to Navigation Key on page 1-505)
Table 1-44 Quick System Check-up
Setting Name
Description
Operation Mode
15-02-60:0
(Standard)
15-02-60:1 (Navi-
gation)
15-02-60:2 (Soft
Key)
System Informa-
tion
Shows the following:
• Version Information
• MAC Address
• Hardware Key
Enter Key + 3 Enter Key + 820 +
Enter Key
Menu + 93 + Eneter
Key
VoIPDB Informa-
tion
Shows the following:
• Type of VoIP Hardware
• Number of VoIP Channels (Top
Right)
• MAC Address
• Active/Reserved
Enter Key + 4 Enter Key + 830 +
Enter Key
Menu + 94 + Enter
Key
IP Address In-
formation
Shows the following:
• System (CPU) IP Address
• VoIPDB IP Address
Enter Key + 6 Enter Key + 840 +
Enter Key
Menu + 96 + Enter
Key
SL1000/SL1100 ISSUE 2.0
1-466
Maintenance
M
To Next Page
Loading...
