Voice/Melody Ringing by VM
Description
This feature enables to play the pre-recorded WAV data (voice or melodies…) instead of ringing tone
to indicate incoming trunk call. It is possible to ring to play the WAV file (address to VM) for each
Caller-ID basis or each ring extension basis, and can be identified to know before answer the call. The
feature also plays Voice/Melody to each ringing Multiline Terminal Extension instead of Caller-ID.
Audio Prompt Format
In order for uploaded greetings to properly play on the SL1000/SL1100 they must be in the proper
format. Audio files not recorded in the proper format may not playback. The proper format is:
Table 1-58 WAV Format
Item Specification
Bit Rate 64 kbps
Sampling Size 8 bits
Channel 1 (Mono)
Sampling Rate 8 kHz
Audio Format CCiTT A-law
Size 1 MB
Length 2 Min.
To upload the WAV file to the system please refer to InMail Upload Download Audio on page 1-388.
Conditions
• The feature basically work with Normal Trunk Incoming call, PBX, CES Incoming Call, DID/DISA/
VRS, DID/DDI and Dial-In in the Tie Line.
• The feature does not work for Internal Incoming Call, Virtual extension ring, Door Box ring, Callback,
Alarm, VRS Waiting Message incoming call.
• This feature is applicable only for Digital Multiline Terminal. Analog phone and IP Phone is not
applicable this feature.
• If all the VRS channels are busy, the normal incoming ring tone takes place.
• The feature works when the Multiline Terminal is idle.
• The feature works during play BGM or Room Monitor.
SL1000/SL1100
ISSUE 2.0
1-734
Voice/Melody Ringing by VM
V
To Next Page
Loading...
