NEC SL1000 - Page 745

• If the WAV file number sets for both Caller-ID ring and Extension ring, the priority of Caller-ID ring is
higher than Extension Ring.
• The Voice channel will be released when the incoming ring has been stopped and stop to play the
WAV file.
• The WAV file is limited to play from a head of melody when receive an incoming call.
• For the occupied channel numbers for VRS incoming message is depending on the number of play
WAV file. Even though the three incoming calls have been received and two calls are used same
WAV file, in case the occupied channel number is two channels. The Ringing terminal numbers are
not related to the count of channels.
• The Ringing priority is as follows;
CID Incoming Voice/Melody Ring (PRG13-04-07) > CID Incoming Ring (PRG13-04-05) > Voice/
Melody ring for each extension (PRG15-02-55) > Normal Ring
• This feature can not be set from Navigation Key.
Default Settings
Disabled
System Availability
Terminals
Digital Multiline Terminal
Required Component(s)
CF Card provided by NEC
VMDB
Related Features
Caller ID
Guide to Feature Programming
Program Num-
ber
Program Name Default Note
13-04-01 Abbreviated Dial Data
Dial Data : 1-9, 0,
*
, #, P, R, @ (Up to 36 digits)
No Setting
13-04-02 Name
Up to 12 characters
No Setting
13-04-03 Transfer Mode
0 = Not defined
1 = Internal dial
2 = Incoming Ring Group
3 = Remote Monitor
0
ISSUE 2.0 SL1000/SL1100
Features and Specifications Manual 1-735
V