Guide to Feature Programming
Program Num-
ber
Program Name Default
20-13-51 Class of Service Options (Supplementary Service) -
Number and Name Appear in the Directory
COS 01~15 = 1
21-01-02 System Options for Outgoing Calls - Intercom Inter-
digit Time
10 (seconds)
Operation
For the Directory Dialing at advance mode (PRG 15-02-60:1 or 2), refer Navigation key feature.
To use Directory Dialing from a Multiline Terminal with an LCD (When set PRG
15-02-60:0):
1. Press the Dir softkey.
- OR -
Press the Right Cursor key.
2. Press the softkey for the Directory Dialing type:
• SPD-Speed Dials
• EXT-co-worker’s Extensions
• STA-Personal Speed Dials
• TELBK-Telephone Book
Directory Dialing follows any feature restrictions that your system may have enabled. For example, if
your extension cannot normally use Speed Dial - System/Group/Station, Directory Dialing can not
access it either.
3. Dial letter/number range for the party you want to call (e.g., dial 2 for A, B, C or 2).
You can enter several letters to help narrow the search.
Press # to enter additional letters on the same key (ex: TOM = 8666#6).
4. Press the Down Arrow softkey to jump to that section.
5. Press the Volume or key to scroll through the list.
If you wait too long between your selections, Directory Dialing automatically cancels.
6. Lift the handset or press the DIAL softkey or Speaker key to place the selected call.
If you selected an outside call, it routes according to your system Trunk Group Routing/ARS setup.
To cancel Directory Dialing:
Press Exit key.
SL1000/SL1100
ISSUE 2.0
1-226
Directory Dialing
D
To Next Page
Loading...
