NEC SL1000 - Page 312

Program
Number
Program Name Description/Comments Assigned Data
42-02-01 Hotel/motel Telephone
Setup - Hotel Mode
Determines if an extension is defined
as a hotel extension
0 = Normal 1 = Hotel.
(default = Normal)
42-02-02 Hotel/motel Telephone
Setup - Check-in Class
Determines the toll restriction class
applied when an extension is
checked in
1-15
(default=1)
42-03-13 Class of Service Op-
tions (Hotel Service) -
PMS Restriction Level
Determines the PMS Restriction Lev-
el.
0 : Off 1 : On
(default = 1 (All Classes))
42-05-05 Room Data Output for
Hotel Service - PMS
Protocol type
Determines the PMS Protocol type. 0 : Normal 1 : Fidelio
(default = 0)
42-06-01 PMS Service Setting -
PMS Port
Determine the TCP port the applica-
tion should connect to for the integra-
tion stream.
0-65535
(default = 5129)
42-06-02 PMS Service Setting -
3:00 AM Auto Room
Scan
Determine if the system scans the
status of Hotel rooms at 3:00AM
0=off, 1=on
(default = 0)
42-06-03 PMS Service Setting -
Check-in Message
Determines whether a check-in or Out
Message is sent when the action is
performed on th ePBX
0 : Off 1 : On
(default = 0)
42-06-04 PMS Service Setting -
Check Out Automatic
Status Change
Determines the room status when a
room is checked out
0=Checked out, 1=Checked out and dirty
(default =0)
42-06-05 PMS Service Setting -
AreYouThere/LineTest
Duration
Defines the time that passes after any
PMS message sent from the PBX that
the PBX sends an AREYUTHERE
message.
1-128 sec
(default = 10 sec)
42-06-06 PMS Service Setting -
AreYouThere/LineTest
Send Count
This is the retry count for un-acknowl-
edged AREYUTHERE messages.
When this consecutive count of ARE-
YUTHERE messages is unacknowl-
edged, the PBX assumes the PMS
link to be inoperational (off-line)
0-20 sec
(default =3)
42-06-07 Check-Out Auto Flexi-
ble Status Change
When PRG 42-06-07 and PRG
42-06-04 are set to on, the status pro-
grammed with PRG 42-06-08 can be
set upon checkout regardless of the
previous status.
0 : Off 1 : On
(default = 0)
42-06-08 Status for Check-Out
Auto Flexible Status
Change
When PRG 42-06-07 is set to on, the
status programmed with PRG
42-06-08 can be set upon checkout.
1 = Room Clean (Occupied)
2 = Maid Required
3 = Maid in Room
4 = Inspection Required
5 = Maintenance Request
6 = Out of Order
7 = Reserve 1
8 = Reserve 2
9 = Reserve 3
0 = Room Clean (Vacant)
*
= Reserve 5
# = Reserve 6
42-07-01 PMS Restriction Level
Conversion
Defines the toll restriction class ap-
plied when a restriction level is re-
ceived from the front of house sys-
tem.
1-15
(default 0=10, 1=11, 2=12, 3=13)
Operation
None
SL1000/SL1100
ISSUE 2.0
1-302
Hotel/Motel - PMS Integration
H