NEC SL1000 - Page 433

Program
Number
Program Name Default Note
84-13-41 SIP Trunk CODEC Information Basic Setup - G.726 Jitter Buf-
fer - Standard
60
84-13-42 SIP Trunk CODEC Information Basic Setup - G.726 Jitter Buf-
fer - Maximum
120
84-13-49 SIP Trunk CODEC Information Basic Setup - RTP Filter 0
84-13-50 SIP Trunk CODEC Information Basic Setup - Fax Relay mode 0
84-13-51 SIP Trunk CODEC Information Basic Setup - T.38 Protocol
mode
1
84-13-52 SIP Trunk CODEC Information Basic Setup - Fax Max Rate 5
84-13-56 SIP Trunk CODEC Information Basic Setup - Low Speed Data
Redundancy
0
84-13-57 SIP Trunk CODEC Information Basic Setup - High Speed Da-
ta Rebundancy
0
84-13-58 SIP Trunk CODEC Information Basic Setup - TCF Handling 1
84-13-61 SIP Trunk CODEC Information Basic Setup - T.38 RTP For-
mat Payload Number
100
84-13-65 VAD Negotiation on SDP
Support G.711 and G.729
0 (V2.0 Added)
15-03-18 Select Special Terminal
Only able to use this program when 15-03-03 is set to 1: Spe-
cial
0 = FAX (V2.0 Added)
84-13-66 Voice Band Data (VBD)
Only able to use this program when 15-03-03 is set to 1:Spe-
cial
0 = Disable (V2.0 Added)
84-13-67 VBD Payload Type 97 (V2.0 Added)
84-14-06 SIP Trunk Basic Information Setup - SIP Trunk Port Number 5060
84-14-07 SIP Trunk Basic Information Setup - Session Timer Value 0
84-14-08 SIP Trunk Basic Information Setup - Minimum Session Timer
Value
1800
84-14-09 SIP Trunk Basic Information Setup - Called Party Information 0
84-14-10 SIP Trunk Basic Information Setup - URL Type 0
84-14-13 SIP Trunk Basic Information Setup - Incoming/Outgoing SIP
Trunk for E.164
0 (V2.0 Added)
84-14-16 SIP Trunk Basic Information Setup - URI E.164 Oncoming
Mode
0 (V2.0 Added)
84-26-01 VoIPDB Basic Setup - IP Address 172.16.0.20
84-26-02 VoIPDB Basic Setup - RTP Port Number VoIP GW1 = 10020
84-26-03 VoIPDB Basic Setup - RTCP Port Number (RTP Port Number
+ 1)
VoIP GW1 = 10021
90-10-01 System Alarm Setup - Alarm Type 0
ISSUE 2.0 SL1000/SL1100
Features and Specifications Manual 1-423
I