NEC SL1000 - Page 448

Programming Flowchart for ISDN-PRI - Answering Calls
Yes
Yes
Yes
No
No
No
Enblock
overlap
Start
In PRG 10-03-01, determine the mode of
the IP4WW-1PRIU-C1(0=not set, 1=T-Bus)
In PRG 10-03-03,
enter '0'.
In PRG 10-03-03,
enter '1'.
Is the CRC
Multi-Frame
(CRC4)
used?
In PRG 10-03-04, select the Layer 3 timer type (1-5). The timer
value is set up in PRG 81-06 (T-Bus)
In PRG 10-03-08,
enter '0'.
Is the Dial
Sending Mode
Enblock or
Overlap
Sending?
In PRG 10-03-08,
enter '1'.
In PRG 10-03-09, selent either
Keypad Facility (0) or
Called Party Number (1) for
the dial information element.
In PRG 14-05-01, assign PRI lines
to trunk groups (determines
available channels for PRI lines).
In PRG 21-01-03, enter
the interval for the trunk
interdigit timer.
Is the amount of time the
system waits before placing
the call in a talk state
sufficient?
Go To
A
In PRG 20-19-04,
set the timer to '0'.
PRG 20-19-04, set the
timer to at least '10'
seconds.
Do you wish to have
the Caller ID
Name displayed for
incoming calls?
In PRG 10-03-06, determine the length of cable used to connect from the
CSU to the IP4WW-1PRIU-C1
(0=0-40m, 1=40-81m, 2=81-122m, 3=122-162m, 4=162-200m).
SL1000/SL1100 ISSUE 2.0
1-438
ISDN Compatibility
I