Placing a Call from the Mobile Extension:
1. Dial the DID or DIL telephone number for the Mobile Extension.
If the Caller ID of the Mobile Extension matches the Speed Dial bin entry (PRG 13-04 and PRG
15-22), internal dial tone is heard by the Mobile Extension user.
2. Dial the desired Intercom number or dial the trunk access code to place an outgoing call.
Answering a Call on the Mobile Extension:
1. Answer the ringing call.
2. If PRG 15-22-02 is set to 0 or 1, the Mobile Extension user hears Music on Hold/ring tone. Press
(within 10 seconds) to answer the call.
This step is required when using analog trunks for the Mobile Extension feature.
Sending a Flash from the Mobile Extension:
1. While on a conversation, a hook flash is returned by dialing
# from the Mobile Extension.
Internal Dial Tone After Hang Up:
1. When a call is finished, disconnect the call and receive internal dial tone by dialing
0.
Placing/Retrieving a Call on Hold from the Mobile Extension:
1. While on a call, dial
#.
2. To retrieve the held call, with system dial tone, dial
#.
Swapping Between Two Held Calls from the Mobile Extension:
1. While on a call, dial
#.
The first call is placed on Hold.
2. Place second call, then place on Hold by dialing
#.
The second call is placed on Hold and the first call is picked up.
3. The Mobile Extension can connect the two held calls with Automatic On-Hook Transfer if PRG
20-11-11 is enabled by dialing
0.
Transferring a call from the Mobile Extension:
1. With an active call, dial
#.
2. Dial the extension number to which the call is to be transferred.
3. Dial
0.
4. Hang up.
Call Forwarding
When setting Call Forwarding from the Mobile Extension, the service code(s) must be redefined in
PRG 11-10-18, PRG 11-11-06 and PRG 11-11-40 and also must be defined in PRG 11-11-01 ~ PRG
11-11-05 and PRG 11-11-07.
SL1000/SL1100
ISSUE 2.0
1-492
Mobile Extension
M
To Next Page
Loading...
