NEC SL1000 - Page 601

Guide to Feature Programming
Program
Number
Program Name Default
15-07-01 Programmable Function Keys Refer to Programming Manual.
20-13-49 Class of Service Options (Supplementary Service) - BLF Indi-
cation on CO Incoming State
COS 01~15 = 0
15-13-01 Loop Keys - Outgoing Option 0: Programming Function Key No. =
01-24
15-13-02 Loop Keys - Incoming Option 0: Programming Function Key No. =
01-24
22-01-04 System Options for Incoming Calls - DIL No Answer Recall
Time
0 (seconds)
22-02-01 Incoming Call Trunk Setup 0
22-04-01 Incoming Extension Ring Group Assignment Extension 200 (first port)
22-05-01 Incoming Trunk Ring Group Assignment 1
22-06-01 Normal Incoming Ring Mode 1
22-08-01 DIL/IRG No Answer Destination 0
22-11-05/06 DID Translation Table - Transfer Target 1 & 2 0
22-12-01 DID Intercept Ring Group 1
25-03-01 VRS/DISA Transfer Ring Group With Incorrect Dialing 0
Use the charts below to program the following example:
For this extension . . .
*1*2
301 Trunk 1 Rings Trunk 2 Flashes Trunk 3 Flashes
302 Trunk 1 Flashes Trunk 2 Rings Trunk 3 Flashes
303 Trunk 1 Flashes Trunk 2 Flashes Trunk 3 Rings
*1. Trunks ring the same in the day as at night.
*2. MLT has trunk appearances not CAP keys.
PRG 22-04 : Incoming Extension Ring Group Assignment
Ring Group
*1
>
1 2 3
Trunk 1 X -- --
Trunk 2 -- X --
Trunk 3 -- -- X
*1. Make the same PRG 22-04 entry for all Night Service modes.
X = Trunk assigned to indicated Ring Group
PRG 22-05 : Incoming Trunk Ring Group Assignment
Ring Group > 1 2 3
Ext. 301 1
0
*1
0
*1
Ext. 302
0
*1
1
0
*1
ISSUE 2.0 SL1000/SL1100
Features and Specifications Manual 1-591
R