140 Operation and Maintenance
Relocation and Storage
For relocating or storage of US40a, contact your service representative.
WARNING
Observe the following instructions to use US40a safely. Failure to follow these
instructions may result in death or serious personal injury. See pages iv to xi for
details.
■ Do not disassemble, repair, or alter US40a.
■ Do not remove the lithium battery.
■ Do not handle US40a with the power cord of US40a being connected to a power
source.
CAUTION
Observe the following instructions to use US40a safely. Failure to follow these
instructions may cause a fire, personal injury, or property damage. See pages iv to
xi for details.
■ Pay attention not to drop US40a.
■ Pay attention not to pinch your finger.
■ Pay attention to extreme high temperature.
IMPORTANT:
For a major work such as floor layout change, contact your sales or
service representative.
To operate US40a and built-in devices appropriately in the next
operation, it is recommended to keep US40a in a place where the
room temperature can be maintained. To store US40a, obey the
storage environmental conditions (temperature: -10ºC to 55ºC,
humidity: 20% to 80% and no condensation)
1. Turn off the power of US40a. (The Power status LED goes off.)
2. Pull out the power cord connected to US40a from the inlet.
3. Remove all cables connected to US40a.
4. Pack US40a securely so as to avoid damages, shock and vibration.
IMPORTANT: Before operating US40a again after transportation or
storage, first check and adjust the system clock. If the system clock
delays or advances remarkably as passage of time in spite of adjustment,
contact your sales or service representative for maintenance. When
US40a and built-in optional devices are moved from a cold site to a
warm site, condensation may occurs and using them without any
adjustment may cause some malfunction or fault to occur. Before the
devices are operated again after transportation or storage, they should
be suitable for the usage environment sufficiently.
To Next Page
Loading...
