EasyManua.ls Logo

NEC US40a - Adding Battery Pack; Battery Pack Addition Procedure

NEC US40a
166 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24 About US40a
Adding Battery Pack
WARNING
Do not put a battery in fire.
Putting the battery in fire or heating the battery may cause an explosion.
Do not disassemble or alter the battery unit.
Do not disassemble or alter the battery unit. Doing so may cause an explosion or a
liquid leakage. The quality, performance, and/or safety of the disassembled or altered
battery unit will not be guaranteed.
Always charge battery by the specified method.
When charging battery, follow procedures described in User's Guide of US40a. Using
any other method may cause a heat generation, an ignition, and/or liquid leakage.
Do not give any shock on the battery unit.
Doing so may cause fumes, ignition, explosion and/or liquid leakage.
CAUTION
Keep the battery in the place away from children and babies.
The toxic substance contained in the battery is harmful if it is taken into the body by
mistake. Consult your doctor immediately if it is swallowed.
Do not use your hand to slide the battery release latch.
Use a ballpoint pen or the like to slide the battery release latch. Using your finger to
slide the battery release latch may cause a damage to your finger.
Battery Pack Addition Procedure
NOTES:
Do not make your body contact with the terminals on the battery
slot. Failure to follow this may cause poor contact to occur.
Use a ballpoint pen or so to slide the battery removal latch. If the
battery removal latch is slid with a finger, it may be injured.

Table of Contents

Related product manuals