Using Features of US40a 59
Wireless Network Connection
To use wireless LAN for US40a, define the network to be used as described below.
You can select the wireless network to be connected to US40a, provide detailed settings for the
connection and specify the IP address.
Wireless Network Connection
Wireless Network Connection Setting Procedure
Set the Wireless Network Connection in the following steps:
1. Select the network to be connected to US40a out of the list of wireless networks within
the possible range, and click [Connect].
If the network to be connected does not appear, select [Refresh network list] on [Network
Tasks] to update the network list.
2. If a network key intended to connect US40a to wireless LAN is defined by a network
administrator, the dialog box requesting the network key appears. Enter the network key.
3. Make sure that [Connect] appears on the [Wireless Network Connection] dialog box.
If so, the connection to the wireless network is completed.
NOTES:
The setting procedure may vary depending on the network to which
US40a connects. For other setting procedures, contact your network
administrator.
You cannot use [Wireless Network Setup] wizard.
To Next Page
Loading...
