NEC US40a - Security

About US40a 39
Security
If you move the cursor to [Security], then the Security menu appears.
When you press Enter under selection of Supervisor Password or User Password, the screen for
registering or changing the password appears. You can set the password on the screen.
IMPORTANT:
 Do not set the passwords unless OS is installed.
 If you forget the passwords, contact your service representative.
See the table below for each item.
Item Parameter Description
Supervisor Password Indicates whether the supervisor password is
specified or not.
User Password Indicates whether the user password is
specified or not.
Change Supervisor Password Allows you to change the supervisor password.
Change User Password Allows you to change the user password.
F8 Hot Key [Enabled]
Disabled
Enables or disables the F8 hot key.
F12 Hot Key [Enabled]
Disabled
Enables or disables the F12 hot key.
[ ]: Factory-set value