This manual describes how to use the audio-video (AV) local browser user interface (UI)
to manage and monitor the switch. We abbreviate the audio-video local browser UI as
the AV UI.
The AV UI is a web-based management tool that lets you configure and manage
audio-video and other types of network profiles remotely using a standard web browser.
Note: To configure all available switch features, including VLANs, QoS, and ACLs, use
the main UI.
Use a web browser to log in to the AV UI
If this is the first time that you log in to the switch and you must use the default IP address
of the switch, see the information in the installation guide. You can use a web browser
to access the switch and log in. You must be able to ping the IP address of the
management interface or out-of-band (OOB) port from your computer for web access
to be available.
Note: The first time that you log in as an admin user to either the AV UI or the main UI,
no password is required (that is, the password is blank). After you log in for the first time,
you are required to specify a local device password that you must use each subsequent
time that you log in to either the AV UI or the main UI. (Using the main UI, you can change
the password again.)
Log in to the AV UI using the management interface default
IP address
Any Ethernet interface can function as the management interface.
To use the default IP address of the management interface to access the switch
over the AV UI:
1. Prepare your computer with a static IP address in the 169.254.0.0 subnet with subnet
mask 255.255.0.0.
For example, use 169.254.100.201 for your computer.
2.
Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet
network port on the switch.
3. Launch a web browser.
4.
Enter http://169.254.100.100 in the web browser address field:
The login page displays.
Audio Video User Manual10Getting Started with the AV UI
AV Line of Fully Managed Switches M4250 Series
To Next Page
Loading...
Need help?
General
