Enable or disable Auto-Trunks
By default, the Auto-Trunk feature is globally enabled but you can globally disable it.
To enable or disable Auto-Trunks:
1. Launch a web browser.
2.
In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3.
In the Login Name field, enter admin as the user name, in the Password field, enter
your local device password, and click the AV UI Login button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The Overview page displays.
4.
Select Configure > Network Profiles.
The Network Profiles page displays.
5.
Below the graphical display of the switch, do one of the following:
•
Disable Auto-Trunks: Do the following:
a.
Turn off the toggle so that it displays gray and is positioned to the left.
A pop-up window displays a warning.
b. Click the Yes button.
Your settings are saved.
•
Enable Auto-Trunks: Turn on the toggle so that it displays green and is positioned
to the right.
Your settings are saved automatically.
6.
To save the settings to the running configuration, at the top of the page, click the
Save icon or text.
Configure PTP residency time stamping
Depending on the network profile that is enabled, you can disable or enable the PTP
residency time stamping manually, which then applies globally.
If a network profile that uses AVB is enabled (for example, a network profile that is based
on Audio AVB), PTP residency time stamping is automatically disabled and you cannot
manually enable it.
Audio Video User Manual29Audio-Video Profile Templates
and Network Profiles
AV Line of Fully Managed Switches M4250 Series
To Next Page
Loading...
Need help?
General
