6
Port Configuration
For the physical ports and LAGs on the switch, you can display the settings and configure
the administrative mode of a port or LAG (both of which are enabled by default), the
frame size for a port, and the flow control for a port. You can also add port descriptions.
Note: In this chapter, we use the term interface to indicate both physical ports and link
aggregation interfaces..
The chapter contains the following sections:
• Administratively enable or disable one or more interfaces
• Add a description to one or more interfaces
• Set the frame size for one or more interfaces
• Configure flow control for one or more interfaces
• Display detailed information about the physical ports and LAGs
56
To Next Page
Loading...
