NETGEAR WAX204

Enable QoS and automatically set the
Internet bandwidth
You can enable QoS and let the access point automatically set its Internet download
and upload bandwidth based on an automated speedtest. Although can you manually
set the download and upload speed (see Enable QoS and manually set the Internet
bandwidth on page 101), we recommend that use the automatic method that is described
in the following procedure.
To enable QoS and set the Internet download and upload bandwidth based on a
speedtest:
1.
Launch a web browser from a computer or mobile device that is connected to the
access point network.
2.
Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4.
Select BASIC > Quality of Service.
The QoS Setup page displays. By default, Quality of Service (QoS) is enabled, and
the Enable QoS check box is selected.
5. Click the Take A Speedtest button.
The speed test checks the access point download and uplink bandwidth, sets the
detected bandwidths, and displays the results on the page.
6. Click the Apply button.
Your settings are saved.
User Manual100Optimize Performance
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204