NETGEAR WAX204

7. Click the Edit Service button.
The Port Triggering - Services page displays.
8. Change the settings.
For information about the settings, see Add a port triggering rule [router mode] on
page 214.
9. Click the Apply button.
Your settings are saved. The changed rule displays in the Port Triggering Portmap
Table on the Port Forwarding / Port Triggering page.
Remove a port triggering rule [router mode]
If the access point is in router mode, you can remove a port triggering rule that you no
longer need.
To remove a port triggering rule:
1.
Launch a web browser from a computer or mobile device that is connected to the
access point network.
2.
Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4.
Select ADVANCED > Advanced Setup > Port Forwarding / Port Triggering.
The Port Forwarding / Port Triggering page displays.
5. Select the Port Triggering radio button.
The port triggering settings display.
User Manual217Port Forwarding and Port
Triggering [Router Mode]
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204