NETGEAR WAX204

In access point mode, the IP address is a LAN IP address. In router mode, the IP
address is a WAN IP address.
•
Lease Obtained. The date and time when the DHCP IP address lease was
obtained.
•
Lease Expires. The date and time that the DHCP IP address lease expires.
6.
When the access point receives an IP address dynamically, you can perform the
following actions:
•
Release. Click the Release button to terminate the DHCP IP address, that is,
terminate the Internet connection.
•
Renew. Click the Renew button to renew the DHCP IP address, that is, renew
the Internet connection.
Display the Internet port statistics
To display the Internet port statistics:
1.
Launch a web browser from a computer or mobile device that is connected to the
access point network.
2.
Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED.
The ADVANCED Home page displays.
5. In the Internet Port pane (in router mode) or in the LAN Port pane (in access point
mode), click the Show Statistics button.
User Manual153Maintain and Monitor
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204