NETGEAR WAX204

If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Setup > LAN Setup.
The LAN Setup page displays.
5.
In the IP Address fields, enter the new LAN IP address.
The LAN IP address at which you can access the local browser UI of the access point
also changes.
6.
In the IP Subnet Mask fields, enter the new LAN subnet mask.
The LAN IP subnet mask at which you can access the local browser UI of the access
point also changes.
7. Click the Apply button.
Your settings are saved.
If you changed the LAN IP address settings of the default LAN subnet, you are
disconnected from the local browser UI.
To reconnect, close your browser, relaunch it, and log in to the access point at its
new LAN IP address.
Manage the DHCP server address pool [router mode]
If the access point is in router mode, it functions as a Dynamic Host Configuration
Protocol (DHCP) server. The access point assigns IP, DNS server, and default gateway
addresses to all computers and mobile devices that are connected to its LAN subnet.
These addresses are part of the same IP address subnet as the access point’s LAN IP
address. By default, the DHCP address pool for the LAN subnet is 192.168.1.2 through
192.168.1.254.
The access point delivers the following parameters to any LAN device that requests
DHCP:
•
An IP address from the range that you define
•
Subnet mask
•
Gateway IP address
User Manual110Network Settings
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204