NETGEAR WAX204

5.
Click the View list of allowed devices not currently connected to the network
link.
A table displays the detected device name, MAC address, and connection type of
the devices that are not connected but allowed to access the network.
6.
To add a device to the allowed list, do the following:
a. Click the Add button.
The Add Allowed Device page displays.
b.
Enter the MAC address and device name for the device that you want to allow.
c. Click the Apply button.
The device is added to the allowed list. The Access Control page displays again.
7.
To remove a device from the allowed list, do the following:
a.
Select the check box for the device.
b.
Click the Remove from the list button.
The device is removed from the allowed list.
8.
To change the MAC address or device for a device on the allowed list, do the
following:
a.
Select the check box for the device.
b. Click the Edit button.
The Edited Allowed Device page displays.
c. Change the MAC address, device name, or both.
d. Click the Apply button.
The Access Control page displays again.
9. Click the Apply button.
Your settings are saved.
Add, remove or change a device on the blocked list
If you set up an access list that allows all new devices from accessing your network but
you want to block some devices, you must set up a blocked list that defines which WiFi
and wired devices are blocked from accessing your network. You do so by adding the
User Manual84Security, Firewall, and Access
Rules
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204