NETGEAR WAX204

•
Port forwarding and port triggering
•
WiFi access
•
Scheduled deactivation of the WiFi signal
•
VPN service
6. Clear the check boxes that correspond to the activities that you do not want to be
logged.
7. Click the Apply button.
Your settings are saved.
View, send, or clear the logs
In addition to viewing the logs, you can send them by email, and clear them.
To view, send, or clear the logs:
1.
Launch a web browser from a computer or mobile device that is connected to the
access point network.
2.
Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Administration > Logs.
The Logs page displays.
5. To send the logs by email, click the Send Log button.
The access point sends the logs to the email address that you specified for email
notifications (see Set up security event email notifications on page 97).
6.
To refresh the log entries onscreen, click the Refresh button.
User Manual145Maintain and Monitor
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204