Your settings are saved, the Advanced Wireless Settings page displays again, and
the new schedule shows in the table for the selected radio.
9.
To enable a schedule immediately, do the following above the table,
In the table, select the radio button for the schedule.
If the table includes a single schedule only, the radio button for the schedule is
already selected.
The radio button for the schedule also lets you select the schedule if you want
to change (edit) or delete it.
Select the Turn off wireless signal by schedule check box.
10. Click the Apply button.
Your settings are saved and the schedule becomes active. The WiFi signal is turned
off according to the schedule that you added.
Enable or disable MU-MIMO
Multiuser multiple input, multiple output (MU-MIMO) improves performance when
multiple MU-MIMO-capable WiFi clients transfer data at the same time. WiFi clients
must support MU-MIMO. This feature is enabled by default, but you can disable it.
Note: When MU-MIMO is enabled, Tx beamforming is automatically enabled and you
cannot disable it.
To enable or disable MU-MIMO:
1.
Launch a web browser from a computer or mobile device that is connected to the
access point network.
2.
Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
User Manual199Advanced WiFi and Radio
Features
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
To Next Page
Loading...
