NETGEAR WAX204

6. Click the Apply button.
Your settings are saved. The radio or radios restart and WiFi clients might need to
reconnect.
Change the transmission output power for
a radio
By default, the transmission output power of the access point is set at the maximum. If
two or more access points are operating in the same area and on the same channel,
interference can occur. In such a situation, you might want to decrease the transmission
output power for one or both radios. Make sure that you comply with the regulatory
requirements for total radio frequency (RF) output power in your country.
IMPORTANT: If the smart connect feature is enabled (which it is by default), any change
in the transmission output power applies to both radios. That means that you cannot
change the transmission output power for each radio individually.
To change the transmission output power for a radio:
1.
Launch a web browser from a computer or mobile device that is connected to the
access point network.
2.
Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > Wireless Settings.
The Wireless Settings page displays. The lower part of the page is called the
Advanced Wireless Settings page. (As you scroll down on the page, the page name
changes.)
User Manual196Advanced WiFi and Radio
Features
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204