The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > WPS Wizard.
The Add WPS Client page displays and shows a description of the WPS method.
5. Click the Next button.
By default, the Push Button (recommended) radio button is selected.
6.
Either click the button onscreen or press the WPS button on the rear panel of the
access point.
For two minutes, the access point attempts to find the WiFi device (that is, the client)
that you want to join the access point’s main WiFi network.
During this time, the WPS LED on the top panel of the access point blinks slowly.
7. Within two minutes, go to the WiFi device and press its WPS button to join the access
point’s main WiFi network without entering a password.
After the access point establishes a WPS connection, the WiFi LED lights and the
Add WPS Client page displays a confirmation message.
8.
To verify that the WiFi device is connected to the access point’s WiFi network, select
BASIC > Attached Devices.
The WiFi device displays onscreen.
Use WPS with the PIN method
To use the PIN method to connect a WiFi device to the access point’s WiFi network, you
must know the PIN of the WiFi device that you are trying to connect.
To join the access point’s WiFi network using WPS with the PIN method:
1.
Launch a web browser from a computer or mobile device that is connected to the
access point network.
2.
Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
User Manual73Basic WiFi and Radio Features
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
To Next Page
Loading...
