NETGEAR WAX204

13.
If your Internet configuration requires a specific VLAN ID, click the VLAN/Bridge
Settings link.
For more information, see Bridge port and VLAN tag groups [router mode] on page
121.
14. Click the Apply button.
Your settings are saved.
15. Click the Test button to test your Internet connection.
If the NETGEAR website does not display within one minute, see one of the following
sections:
•
You cannot access the Internet [router mode] on page 231
•
Troubleshoot Internet browsing on page 234
Specify a PPPoE Internet connection that uses a login [router
mode]
To specify or view the settings for an ISP Internet connection that uses PPPoE and
that requires a login:
1.
Launch a web browser from a computer or mobile device that is connected to the
access point network.
2.
Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select BASIC > Internet.
The Internet Setup page displays.
User Manual39Manually Set Up Internet
Settings
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204