NETGEAR WAX204

(Continued)
DescriptionField
The IP address of the gateway to which the access point connects to the Internet.Gateway IP Address
The IP address of the Domain Name System (DNS) server that the access point
uses.
Domain Name Server
DescriptionField
Wireless Settings (2.4GHz) or Wireless Settings (5GHz )
To change these settings, see Basic WiFi and Radio Features on page 58 and Advanced WiFi and Radio Features
on page 187.
The name of the SSID (see Set up or change an open or secure WiFi network on
page 59).
Name
The country and region in which the access point is being used (see Change the
region of operation on page 188).
Region
The channel that the radio uses (see Change the channel for a radio on page 193).Channel
The WiFi throughput mode that the radio uses (see Change the WiFi throughput
mode for a radio on page 194).
Mode
Displays if the WiFi network is enabled (see Set up or change an open or secure
WiFi network on page 59 or Enable or disable a WiFi network on page 65).
Wireless AP
Displays if the WiFi network broadcasts its SSID (see Hide or broadcast the SSID
for a WiFi network on page 66).
Broadcast Name
This setting applies to the Wireless 1 network only.
Displays if WPS is enabled.
Note: If you either set up open security for the Wireless 1 network or disable the
WiFi radios, WPS is disabled.
Wi-Fi Protected Setup
Check the Internet connection status
To check the Internet connection status:
1.
Launch a web browser from a computer or mobile device that is connected to the
access point network.
2.
Enter http//www.routerlogin.net in the address field.
User Manual151Maintain and Monitor
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204