NETGEAR WAX204

Disconnect the access point from the VPN
server [router mode]
To disconnect the router from the VPN server and terminate the VPN connection:
1.
Launch a web browser from a computer or mobile device that is connected to the
access point network.
2.
Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select BASIC > VPN Client.
The VPN Client page displays.
5. Click the Disconnect button.
The VPN connection is terminated.
When the access point is disconnected from the VPN server, the Disconnect button
changes into the Connect button, allowing you to reestablish the VPN connection.
User Manual176VPN Client [Router Mode]
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204