NETGEAR WAX204

The Setup Wizard searches your Internet connection for servers and protocols to
determine your Internet configuration. When the access point connects to the Internet,
you are prompted to change the local device password (also referred to as the admin
password).
Manually set up the access point Internet
connection [router mode]
If the access point is in router mode, you can view or change the access point’s Internet
connection settings.
Note: The information in this section and subsections does not apply if the access point
is in access point mode.
Specify a dynamic or fixed WAN IP address Internet
connection without a login [router mode]
To specify or view the settings for a WAN Internet connection that uses a dynamic
or fixed IP address and that does not require a login:
1.
Launch a web browser from a computer or mobile device that is connected to the
access point network.
2.
Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select BASIC > Internet.
The Internet Setup page displays.
User Manual37Manually Set Up Internet
Settings
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204