NETGEAR WAX204

•
Secured. In secured mode, which is the default mode, the router inspects both
TCP and UDP packets.
• Open. In open mode, the router inspects UDP packets only.
10. Click the Apply button.
Your settings are saved.
Set up an IPv6 DHCP Internet connection [router mode]
To set up an IPv6 Internet connection with a DHCP server:
1.
Launch a web browser from a computer or mobile device that is connected to the
access point network.
2.
Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > IPv6.
The IPv6 page displays.
5. From the Internet Connection Type menu, select DHCP.
The page adjusts. The access point automatically detects the information in the
following fields:
•
Router’s IPv6 Address on WAN. This field shows the IPv6 address that is acquired
for the access point’s WAN (or Internet) interface. The number after the slash (/)
is the length of the prefix, which is also indicated by the underline (_) under the
IPv6 address. If no address is acquired, the field displays Not Available.
•
Router’s IPv6 Address on LAN. This field shows the IPv6 address that is acquired
for the access point’s LAN interface. The number after the slash (/) is the length
User Manual54Manually Set Up Internet
Settings
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204