NETGEAR WAX204

7. Change the settings.
For more information about the settings, see Add a service blocking rule for a custom
service or application [router mode] on page 91.
8. Click the Apply button.
Your settings are saved. The modified rule displays in the Service Table on the Block
Services page.
Remove a service blocking rule [router mode]
If the access point is in router mode, you can remove a service blocking rule that you
no longer need.
To remove a service blocking rule:
1.
Launch a web browser from a computer or mobile device that is connected to the
access point network.
2.
Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Security > Block Services.
The Block Services page displays.
5.
In the Service Table, select the radio button for the rule.
6. Click the Delete button.
The rule is removed from the Service Table. Custom rules are deleted.
User Manual94Security, Firewall, and Access
Rules
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204