NETGEAR WAX204

computer or mobile device is on the same subnet as the LAN subnet of the
existing network router to which the access point is connected.
Most computers and mobile devices function as DHCP clients. If your computer or
mobile device does not, enable its DHCP client so that is can obtain an IP address
automatically using DHCP.
Standard LED behavior when the access
point is powered on
After you turn on power to the access point, verify that the following sequence of events
occurs:
1.
When power is first applied, verify that the Power LED is lit.
2.
After about two minutes, verify the following:
•
The Power LED is solid green.
•
The Internet LED is solid or blinking green.
•
The WiFi LED is solid or blinking green.
•
If a powered-up LAN device is connected to one of the LAN ports of the access
point, the LAN LED is solid or blinking green, or solid or blinking amber,
depending on the speed of the connection.
You can use the LEDs on the top panel of the access point for troubleshooting (see
Troubleshoot with the LEDs on page 225)
Troubleshoot with the LEDs
You can troubleshoot by checking the LEDs.
Power LED is off
This could occur for a number of reasons. Check the following:
•
Make sure that the power adapter is securely connected to your access point and
securely connected to a working power outlet.
•
Make sure that you are using the power adapter that NETGEAR supplied for this
product.
User Manual225Diagnostics and
Troubleshooting
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204