NETGEAR WAX204

12. Click the Apply button.
Your settings are saved. The access point restarts with a new IP address.
13. To reconnect, close your browser, relaunch it, and log in to the access point by
entering http//www.routerlogin.net.
Change the CTS/RTS threshold and
preamble mode for a radio
For most WiFi networks, the CTS/RTS threshold and preamble mode work fine and we
recommend that you do not change the settings. (In general, these settings are intended
for WiFi testing.)
CAUTION: Do not change these settings unless directed by NETGEAR support or
unless you are sure what the consequences are. Incorrect settings might disable the
WiFi function of a radio unexpectedly.
IMPORTANT: If the smart connect feature is enabled (which it is by default), the CTS/RTS
threshold and preamble mode apply to both radios. That means that you cannot change
the CTS/RTS threshold and preamble mode for each radio individually.
To change the CTS/RTS threshold and preamble mode for a radio:
1.
Launch a web browser from a computer or mobile device that is connected to the
access point network.
2.
Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
User Manual205Advanced WiFi and Radio
Features
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204