NETGEAR WAX204

A pop-up window displays, showing the following information:
•
System Up Time. The time elapsed since the access point was last restarted.
•
Port. The statistics for the WAN (Internet) port, LAN (Ethernet) ports, and WLANs.
For each port, the window displays the following information:
-
Status. The link status of the port.
-
TxPkts. The number of packets transmitted on this port since reset or manual
clear.
-
RxPkts. The number of packets received on this port since reset or manual
clear.
-
Collisions. The number of collisions on this port since reset or manual clear.
-
Tx B/s. The current transmission (outbound) bandwidth used on the WAN
and LAN ports.
-
Rx B/s. The current reception (inbound) bandwidth used on the WAN and
LAN ports.
- Up Time. The time elapsed since this port acquired the link.
6.
To manage the polling, do one of the following:
•
To change the polling frequency, which is the interval at which the statistics are
updated in this window, enter a time in seconds in the Poll Interval field and
click the Set Interval button.
•
To stop the polling entirely, click the Stop button.
Display the devices currently on the access point network
and change device information
You can display the active wired and WiFi devices in the access point network. If you
do not recognize a WiFi device, it might be an intruder.
If the access point is in router mode, you can also display the VPN devices in the access
point network.
To display the attached wired, WiFi, and VPN devices or to change device
information:
1.
Launch a web browser from a computer or mobile device that is connected to the
access point network.
2.
Enter http//www.routerlogin.net in the address field.
User Manual154Maintain and Monitor
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204