NETGEAR WAX204

3
Manually Set Up Internet Settings
Usually, the quickest way to set up the Internet connection is to allow the Setup Wizard
to detect the Internet connection when go through the initial log-in procedure. After
initial setup, you can use the Setup Wizard at any time.
If the access point is in router mode, you can specify the WAN (Internet) settings manually,
including IPv6 settings. For information about changing the LAN settings if the access
point is in router mode, see LAN IP address settings [router mode] on page 109.
This chapter contains the following sections:
• Use the Setup Wizard
• Manually set up the access point Internet connection [router mode]
• IPv6 Internet connections and IPv6 addresses [router mode]
35