NETGEAR WAX204

(Continued)
DescriptionField
For WiFi devices, the connection type information shows the radio and WiFi network
(Wireless 1, Wireless 2, or Wireless 3) to which the device is connected.
For LAN devices, the connection type is always Wired.
Connection Type
The device name, if detected. This field also displays the device model, if detected,
and device type icon. This information is for display only.
You can change the information that displays (see Step 5).
Device Name,
including device
model and device type
icon
The IP address that is assigned to the device when it joined the access point network.
This address can change when a device is disconnected and rejoins the network.
Note: If you enable access control or QoS, the IP address is displayed in the Device
Name field.
IP Address
If QoS is enabled (see Enable QoS and automatically set the Internet bandwidth on
page 100 or Enable QoS and manually set the Internet bandwidth on page 101), the
download speed in Mbps that the device uses.
Internet Download
Speed by Device
If QoS is enabled (see Enable QoS and automatically set the Internet bandwidth on
page 100 or Enable QoS and manually set the Internet bandwidth on page 101), the
unload speed in Mbps that the device uses.
Internet Upload Speed
by Device
The following information displays only if the access point is in router mode and
supports VPN clients devices.
DescriptionField
VPN Client Devices
The device name, if detected.Device Name
The IP address of the device at the other side of the VPN tunnel.Remote IP Address
User Manual156Maintain and Monitor
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204