NETGEAR WAX204

4.
Select ADVANCED > Advanced Setup > Traffic Meter.
The Traffic Meter page displays.
5.
Select the Enable Traffic Meter check box.
6. Select the Connection time control radio button.
The access point must be connected to the Internet for you to be able to select the
Connection time control radio button.
7.
In the Monthly Limit field, enter how many hours per month are allowed.
The access point must be connected to the Internet for you to be able to enter
information in the Monthly Limit field.
8.
In the Traffic Counter section, set the traffic counter to begin at a specific time and
date.
9.
In the Traffic Control section, enter a period in minutes to specify when the access
point issues a warning message before the monthly limit in hours is reached.
This setting is optional. The access point issues a warning when the balance falls
under the number of minutes that you enter. By default, the value is 0 and no warning
message is issued.
10.
Select one or more of the following actions to occur when the limit is reached:
• Turn the Internet LED to blinking green or amber. This setting is optional. When
the traffic limit is reached, the Internet LED alternates between green and amber.
• Disconnect and disable the Internet connection. This setting is optional. When
the traffic limit is reached, the Internet connection is disconnected and disabled.
11. Click the Apply button.
Your settings are saved.
The Internet Traffic Statistics section helps you to monitor the data traffic. For more
information, see View the Internet traffic volume and statistics [router mode] on page
162.
User Manual161Maintain and Monitor
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204