Installation and Basic Configuration
20
ProSafe Dual Band Wireless-N Access Point WNDAP360
To configure time settings:
1. Select Configuration > System > Basic > Time. The Time screen displays:
Figure 9.
2. Specify the fields as explained in the following table:
3. Click Apply
to save your settings.
Table 3. Time System Settings
Field Description
Time Zone Select the time zone to match your location.
Current Time This is a nonconfigurable field that
displays the current date and time.
NTP Client Enable the Network Time Protocol (NTP) client to synchronize the time of the
wireless access point with an NTP server. By default the Enable radio button is
selected.
Use Custom NTP Server Select this check box to If you wan
t to use a custom NTP server.
Note: You need to have an Internet connection to use an NTP server that is
not
on your local network.
Hostname /
IP Address
Enter the host name or IP address of
the custom NTP server.
The default is time-b.netgear.com.
Note: If you use a host name, make sure that you have
configu
red a DNS server. For more information, see the next
section.