OPR360US H0711
1-8
1
Introduction
Gas Warnings
Danger: There is a risk of explosion if used in the presence of
flammable anesthetics. The system is not intended for use with
anesthetic gases.
Use only dry clean, particle-free compressed air.
Oxygen source gas must be medical grade, 100% oxygen.
Auxiliary Equipment Warnings
Newport Medical cannot warrant or endorse the safe performance
of third party humidifiers for use with the e360 Ventilator. Contact
the manufacturers/distributors of third party humidifiers about the
compliance and performance characteristics of their products.
Cautions
Follow these safety guidelines. Additional cautions appear in context
throughout this document.
Use only fuses with the correct rating.
Do not immerse the ventilator in liquid sterilizing agents or liquids of
any kind.
Do not spray cleaning solutions directly onto the front or rear panels
of the ventilator.
Do not allow cleaning solutions to pool on the ventilator control panel
or top of ventilator.
Do not place liquids on or near the ventilator.
Check with the manufacturer of all cleaning chemicals and sterilizing
equipment to ensure safe handling procedures are followed.
The Exhalation Flow Sensor is a precise and delicate instrument.
Take care when handling not to disturb the measuring wires. Do not
insert any object into the flow sensor, nor direct pressurized flows of
liquids or gases through the sensor during cleaning and reprocessing.
The life cycle of the sensor is limited and will depend on observance
of safe handling precautions and the ability to calibrate the sensor.
Always make sure that the flow sensor is completely dry before
installation.
To Next Page
Loading...
