OPR360US H0711
2-2
2
Overview
Rear Panel Layout
The e360 rear panel contains the On/Off power switch, Air/Oxygen
inlets, and other connections for various external devices.
Refer to Foldout F-2 for rear panel view and description of connections.
NOTE: Make sure that the e360 is completely shutdown before the
power switch is turned on again. If the power switch is turned off and
then on too quickly and the screen does not load correctly, turn the
power off and wait 15 seconds before powering ON the ventilator.
Navigating the Control Panel
Refer to Foldout F-4 for a full view of the e360 Control Panel
functions described here.
Using Touch - Turn - Accept
Most ventilation and alarm controls on the Control Panel and the GUI
are adjusted with the Touch-Turn-Accept method. There are a few
exceptions which are noted with the description of the control.
1. Inspiratory (To Patient) Port 22 mm OD
2. Expiratory (From Patient) Port 22 mm OD
3. Exhalation Valve
4. Exhalation Flow Sensor
5. Flow Sensor Cable connection
Figure 2-1 Lower Front Panel Layout
To Next Page
Loading...
