Newport e360 - Air, O2 and AC Power Connections; Install the Breathing Circuit System

OPR360U A0509
5-1
5
OPR360U A0509
5-1
5
OPR360U A0509
5-1
5
OPR360U A0509
5-1
5
OPR360US H0711
3-6
3
Unpacking, Assembly, and Safety Check
EnsurethattheACpowercordisconnectedtothettingontheback
oftheventilator.Tightentheretainingclampasneededtosecurethe
cord.SeeFigure3-6,B.
Caution Periodically inspect the air and oxygen inlet water traps and
drain water from the bowls as necessary by pressing the pin at the
bottom of the bowl.
Install the Breathing Circuit System
1. FirmlyinstallthedisposableltersontheTo Patient port and the
From Patient port.
Optional:IftheExpiratoryFilterHeaterisinuse,installalterinto
the heated system instead of on the From Patient port.
2. Installatwo-limbbreathingcircuitandhumidicationsystem 
 accordingtopatientrequirements.SeeFigure3-7,3-8and3-9
for setup options.
A
B
Figure 3-6 Air, O2 and AC Power Connections