107
4 Start the timer.
Press the shutter-release
button all the way down
to start the timer.
The
self-timer lamp will start
to flash.
Two seconds before the photograph is taken, the
self-timer lamp will stop flashing.
The shutter will be released
about ten seconds after the timer starts.
To turn the self-timer off before a photograph is taken, turn the
release mode dial to another setting.
A Using the Built-in Flash
Before taking a photograph with the flash, press the flash pop-up
button to raise the flash and wait for the M indicator to be displayed in
the viewfinder (0 189).
Shooting will be interrupted if the flash is
raised after the self-timer has started.
Note that only one photograph
will be taken when the flash fires, regardless of the number of
exposures selected for Custom Setting c3 (Self-timer; 0 319).
A See Also
For information on choosing the duration of the self-timer, the number
of shots taken, and the interval between shots, see Custom Setting c3
(Self-timer, 0 319).
For information on controlling the beeps that
sound when the self-timer is used, see Custom Setting d1 (Beep,
0 321).
To Next Page
Loading...
