257
Copy Pictures to the Computer
Before proceeding, be sure you have installed the software on
the supplied ViewNX 2 CD (0 253).
1 Connect the USB cable.
After turning the camera off and ensuring that a memory
card is inserted, connect the supplied USB cable as shown
and then turn the camera on.
Using ViewNX 2
A Use a Reliable Power Source
To ensure that data transfer is not interrupted, be sure the camera
battery is fully charged.
A Connecting Cables
Be sure the camera is off when connecting or disconnecting
interface cables.
Do not use force or attempt to insert the
connectors at an angle.
D During Transfer
Do not turn the camera off or disconnect the USB cable while
transfer is in progress.
To Next Page
Loading...
