Nikon D810 - Page 219

195
A See Also
See page 198 for information on locking flash value (FV) for a metered
subject before recomposing a photograph.
For information on auto FP high-speed sync and choosing a flash sync
speed, see Custom Setting e1 (Flash sync speed, 0 329).
For
information on choosing the slowest shutter speed available when
using the flash, see Custom Setting e2 (Flash shutter speed, 0 331).
For information on flash control and using the built-in flash in
commander mode, see Custom Setting e3 (Flash cntrl for built-in
flash, 0 331).
See page 428 for information on using optional flash units.
A Aperture, Sensitivity, and Flash Range
Flash range varies with sensitivity (ISO equivalency) and aperture.
Maximum aperture at ISO equivalent of Range
64 100 200 400 800 1600 3200 6400 12800 m ft
— 1.4 2 2.8 4 5.6 8 11 16 0.7–8.5 2ft 4in.–27ft 10in.
1.6 2 2.8 4 5.6 8 11 16 22 0.6–6.0 2ft–19ft 8in.
2.2 2.8 4 5.6 8 11 16 22 32 0.6–4.2 2ft–13ft 9in.
3.2 4 5.6 8 11 16 22 32 — 0.6–3.0 2ft–9ft 10in.
4.5 5.6 8 11 16 22 32 — — 0.6–2.1 2ft–6ft 10in.
6.3 8 11 16 22 32 — — — 0.6–1.5 2ft–4ft 11in.
9 11 16 22 32 — — — — 0.6–1.1 2ft–3ft 7in.
13 16 22 32 — — — — — 0.6–0.8 2ft–2ft 7in.
The built-in flash has a minimum range of 0.6 m (2 ft).
In exposure mode e, the maximum aperture (minimum f-number) is
limited according to ISO sensitivity, as shown below:
Maximum aperture at ISO equivalent of:
64 100 200 400 800 1600 3200 6400 12800
2.5 2.8 3.5 4 5 5.6 7.1 8 10
If the maximum aperture of the lens is smaller than given above, the
maximum value for aperture will be the maximum aperture of the lens.