439
Remote
terminal
accessories
The D810 is equipped with a ten-pin remote terminal
(0 3) for remote control and automatic photography.
The terminal is provided with a cap, which protects the
contacts when the terminal is not in use.
The following
accessories can be used (all lengths are approximate):
• Remote Cord MC-22/MC-22A: Remote shutter release with
blue, yellow, and black terminals for connection to a
remote shutter-triggering device, allowing control via
sound or electronic signals (length 1 m/3 ft 3 in.).
• Remote Cord MC-30/MC-30A: Remote shutter release; can be
used to reduce camera shake (length 80 cm/2 ft 7 in.).
• Remote Cord MC-36/MC-36A: Remote shutter release; can be
used for interval timer photography or to reduce
camera shake or keep the shutter open during a time
exposure (length 85 cm/2 ft 9 in.).
• Extension Cord MC-21/MC-21A: Can be connected to ML-3 or
MC-series 20, 22, 22A, 23, 23A, 25, 25A, 30, 30A, 36, or
36A.
Only one MC-21 or MC-21A can be used at a time
(length 3 m/9 ft 10 in.).
• Connecting Cord MC-23/MC-23A: Connects two cameras with
ten-pin remote terminals for simultaneous operation
(length 40 cm/1 ft 4 in.).
• Adapter Cord MC-25/MC-25A: Ten-pin to two-pin adapter
cord for connection to devices with two-pin terminals,
including the MW-2 radio control set, MT-2
intervalometer, and ML-2 modulite remote control set
(length 20 cm/8 in.).
• WR Adapter WR-A10: An adapter used to connect WR-R10
wireless remote controllers (0 441) to cameras with
ten-pin remote terminals.
• GPS Unit GP-1/GP-1A (0 233): Record latitude, longitude,
altitude, and UTC time with pictures.
To Next Page
Loading...
